SHOWTEC LED Par 64 Short DMX Guide de l'utilisateur télécharger pdf (Page 19)

160-169

ID16

170-179

ID17

180-189

ID18

190-199

ID19

200-209

ID20

210

ID21

211

ID22

212

ID23

213

ID24

•

251

ID62

252

ID63

253

ID64

254

ID65

255

ID66

Maintenance

The Showtec Compact Power Lightset requires almost no maintenance. However, you should keep the

unit clean. Otherwise, the fixture’s light-output will be significantly reduced. Disconnect the mains power

supply, and then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass

cleaner and a soft cloth. Do not use alcohol or solvents. Keep connections clean. Disconnect electric

power, and then wipe the connections with a damp cloth. Make sure connections are thoroughly dry

before linking equipment or supplying electric power.

The operator has to make sure that safety-relating and machine-technical installations are to be

inspected by an expert after every four years in the course of an acceptance test.

The operator has to make sure that safety-relating and machine-technical installations are to be

inspected by a skilled person once a year.

The following points have to be considered during the inspection:

1. All screws used for installing the device or parts of the device have to be tightly connected and must

not be corroded.

2. There may not be any deformations on housings, fixations and installation spots.

3. Mechanically moving parts like axles, eyes and others may not show any traces of wearing.

4. The electric power supply cables must not show any damages or material fatigue.

Replacing a Fuse

Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the

fuse burns out, the product will not function whatsoever. If this happens, follow the directions below to do

so.

1. Unplug the unit from electric power source.

2. Insert a screwdriver into the slot in the fuse cover. Turn the screwdriver to the left, at the same time

gently push a bit (Turn and Push). The fuse will come out.

3. Remove the used fuse. If brown or unclear, it is burned out.

4. Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to

use a fuse of the same type and specification. See the product specification label for details.

1 2 ... 14 15 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire

SHOWTEC LED Par 64 Short DMX Guide de l'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Stroboscopes et lampes disco SHOWTEC LED Par 64 Short DMX