SHOWTEC Scanmaster 1 Guide de l'utilisateur télécharger pdf (Page 12)

Copy a Scene

1) Enable Program Mode.

2) Tap the BANK Up/Down button, to select the bank containing the scene you wish to copy.

3) Select the scene you wish to copy, by pressing its SCENE button.

4) Using the BANK Up/Down button, select the bank you wish to copy the scene to.

5) Tap the MIDI/Rec button.

6) Tap the SCENE button you wish to copy the scene to.

Delete a Scene

1) Enable Programming Mode.

2) Press the desired SCENE button, to select the scene you wish to delete.

3) Press and hold down the Auto/Del button. While holding the button, tap the SCENE button that

corresponds with the scene you wish to delete.

4) When the programmed scene is deleted, all DMX channel values will be set to 0.

Delete All Scenes

1) Turn the unit’s power off, then press and hold down the PROGRAM and BANK Down buttons at the same

time.

2) Turn the unit back on, and all scenes should be cleared.

Copy a Bank of Scenes

1) Enable Programming Mode.

2) Tap the BANK Up/Down button until you reach the bank you wish to copy.

3) Tap the MIDI/Rec button.

4) Tap the BANK Up/Down button to select the bank you wish to copy to.

5) Tap the Music/Bank Copy button, all LEDs will briefly flash three times, indicating the function has

been completed.

6) Press the PROGRAM button for three seconds to exit programming mode.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

SHOWTEC Scanmaster 1 Guide de l'utilisateur Page 12