SHOWTEC Phantom 250 Spot Guide de l'utilisateur télécharger pdf (Page 12)

Multiple Phantoms (DMX Control)

1. Fasten the effect light onto firm trussing Leave at least 1 meter on all sides for air circulation.

2. Always use a safety cable.

3. Use a 3-p XLR cable to connect the Phantoms and other devices.

4. Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket to

the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

5. Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the

other end of the mains power cord into proper electric power supply sockets, starting with the first unit.

Do not supply power before the whole system is set up and connected properly.

Multiple Phantoms DMX Set Up

Note : Link all cables before connecting electric power

Fig. 4

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Pas de commentaire

SHOWTEC Phantom 250 Spot Guide de l'utilisateur Page 12